Technical details

• four 16x16 size tables (fuel map,two PWM tables, ignition table),
• 8 Correction tables 16x1,
• 2 independent switchable map sets ,
• possibility modification of one analogue signal,
• 4 analogue inputs,
• inbuilt Data Flash - possibility of logging without PC
• battery voltage monitoring,
• support of frequency output air flow meter (possibility of signal modification) 17Hz-4kHz,
• support VR and Hall effect crank sensors together with ignition modules pulse. Device supports both single ended and differential signals,
• supports a lot of crank trigger patterns: 60-2, 36-2, 36-1, Multitooth, Ignition Modules and more,
• support of waste gate valve,
• output for 4 saturated injectors ("full group"),
• ON/OFF parametric output,
• automatic conversion of MAP to MAF with the use of the learning algorithm,
• launch control,
• road dyno,
• individual calibration of each analogue sensors - device displayed values with correct units,
• free firmware update - new crank trigger patterns and new functionality,
• fuel Implant mode - possibility to drive injectors in standalone mode (batch fire),
• USB communication no additional interface needed,
• 24 months warranty.

PC Requirements

To properly work with the DET3 device following minimum is required.

• Windows 2000, XP, Vista, Wimndows 7, 8,10
• Screen resolution of at least 1024x768 16bit
• CPU with a clock of at least 600MHz
• USB port

What's in the box

• Digital Ecu Tuner 3 device
• USB AA lead
• connector
• set of terminals
• set of resistors and diode which may be useful during installation